Beaudesert Exhausts Rugged 441 Nissan Patrol Y62 2012-Current 5.6L Petrol Exhaust

PLEASE NOTE
If your order is not in stock, the approximate wait time is four to six weeks from the date of your order.  
 

Beaudesert Exhaust’s twin 2 1/2″ into single 3″ mandrel bent exhaust system to suit the Nissan Patrol Y62 5.6L.

Rugged is the Beaudesert standard system which is made out of 441 grade stainless steel tube.

Using the factory exhaust path, Beaudesert Exhaust’s system upsizes the engine pipes to 2.5” lowering exhaust pressure and temperature, whilst also increasing flow. These pipes then merge into a single 3” tube for the remainder of the system.

This system features self-locating V-band clamp system throughout. Not only does this make installation a breeze with the ability to make small adjustments as required, it also removes all exhaust gaskets so you will never have to worry about having an exhaust leak due to a failed gasket. All systems in the range feature braced 12mm 304 grade Stainless Steel hangers and muffler supports. The anti-vibration rubber that is installed on your original exhaust is retained, with a mount featured in the same location to bolt the rubber on.

Fitment has been tested with the Raslarr rear bar and LRA long range fuel tank.

Cat back exhaust – Bolting up behind the primary Catalytic Converters, the Cat back system increases exhaust flow and noise level can be selected with the choice of either rear muffler (mild note) or no rear muffler (louder note).

Full exhaust including Extractors and high flow Catalytic Converters – Expanding the above cat back design, Beaudesert Exhausts own 2mm wall thickness Stainless Steel, 2.5″ Tri-Y extractors and high flow Catalytic Converters. Supplied coated in Cerakote, these Extractors are ready to handle up to 1000°C. Dyno testing has seen an increase of 20hp and 50Nm of torque! Tuning isn’t required and no engine management issues by bolting onto a standard car.

Mandrel bent, welded and manufactured in South East Queensland, this high quality exhaust system includes:
- Double braided Stainless Steel flex joint standard on all systems
- Perforated straight through centre muffler and rear muffler
- No rear muffler pipe available for a louder note
- V-band clamps in 304 grade Stainless Steel
- Reinforced 12mm 304 grade Stainless Steel brackets with supports
- Fitting Kit and easy to follow instructions
- Boxed and bubble wrapped for freight

Also available in Ultimate 304 grade stainless steel.

Full System - Approximate time to install is 7-9 hours

Cat Back System - Approximate time to install is 2-3 hours